Author: Mike Ashcraft

This was inspired by the Slopes go pro mount thing. This is for those of us who use the Yi camera rather than the go pro. Anglez is a simple design with different angles (10, 30, 40 and 45) to sit your YI camera. Lots of ways to sit the camera in for positive or negative angles.

Read More

I found this MOC online to add to my Halloween display and made a few changes to it. If any one wants me to try and make instructions for this shoot me a message and let me know. Credit for the original design goes to gcanik on the eurobricks forum.

Read More

About This is currently a work in progress. Nothing is 100% final yet but here is what I can tell you. This is a true 250mm(motor center to motor center measured diagonally) size quadcopter swinging 6×45 props. As far as I can find there are very few true 250mm size quads capable of swinging 6″ […]

Read More

I picked up an 18″ weather proof case from MCM Electronics the other day to use for my transmitters. They both fit great and I have enough room in the case for my FPV goggles as well. The interior has three layers of foam. The top layer in the lid is egg crate style foam, then […]

Read More

If your using the MC2204 motors from fpvmodel.com then check out this drill guide I made to make custom mounts easier to make.

Read More

Here is a design I worked up to hold lipo batteries to round tripod legs. A lot of rc model flyers use tripods to hold there fpv receivers and battery.

Read More

This is an EPP foam trainer that I picked up from West Michigan Park Flyers for my son to learn on. Currently it is done but needs some adjustment as its pulling to the left for some reason. I will get some more pictures and add them to this post to give a better idea of […]

Read More