I have started a new CCG and with it comes new storage solution problems. I have designed this dice/token tray to fit inside a normal ultra pro deck box along with the normal sleeved 30 card Destiny deck. Designed in Fusion 360 and the design files are available via the link below.
I have designed a simpler frame for my h8 mini. The last one I was using ended up being weak in a couple spots and this one should solve that problem. Here are some of the features: No supports needed Protected motor wires Light weight I also used this as an excuse to start learning […]
I picked up a VTX03 transmitter and a very small 600TVL 100 Degree camera to go on my H8 Mini or my old Syma X1 after I get one of the Brushed F4 flight controllers. Let me tell you the tx is really small as is the camera. This is a great setup for micro quads […]
Just wanted to give everyone a heads up that banggood has the DYS 6045 Props on sale. You get two pairs for $0.39! I ordered a bunch. Also use coupon code 36bgc8 to save even more. These ship from china so it takes a while.
You may have noticed that there is a distinct lack of “toy” quadcopters that feature rate/acro mode. This is mostly due to them being sold as toys to people who want them easy to fly. For every one who wants to learn how to fly rate/acro mode, your in luck as a bit of cheap […]
I have been working on making my kitchen look better. Part of this process was skim coating the old laminate coutertops with Rapid Set Cement All. First I ran a test on some plywood I had laying around. Looking back this is probably where I made a mistake. I should have tested it on some […]
I’m planing on running mine at less than 200 watts probably 100 watts max. If you want to run this at the full 200 watts I would suggest getting a wider heat sink. The DC to DC boost converter has adjustments for both voltage and amperage so this gives you a great deal of control […]
This was inspired by the Slopes go pro mount thing. This is for those of us who use the Yi camera rather than the go pro. Anglez is a simple design with different angles (10, 30, 40 and 45) to sit your YI camera. Lots of ways to sit the camera in for positive or negative angles.
I found this MOC online to add to my Halloween display and made a few changes to it. If any one wants me to try and make instructions for this shoot me a message and let me know. Credit for the original design goes to gcanik on the eurobricks forum.
About This is currently a work in progress. Nothing is 100% final yet but here is what I can tell you. This is a true 250mm(motor center to motor center measured diagonally) size quadcopter swinging 6×45 props. As far as I can find there are very few true 250mm size quads capable of swinging 6″ […]